Posted by Willy-N [72.171.192.59] on Thursday, March 12, 2015 at 22:54:42 :
Just wanted to pressure wash the grease off today on the engine and frame. Then it snow balled into pulling the transmission and transfer case. I made a mounting base for the bell housing holes to go on the engine stand. Moving it into the shop to put it together. The one that came with it was cheap! I got 85% of the frame is clean and ready to be sand blasted. Un/bolted all the fenders and running board frame brackets now that I can could see the bolt heads good. The pile of iron building up weighs way more than the frame! Once I pull the engine off it will just be Frame and Axles left. I am going to use the trans and transfer case out of the 53PW since there clean now.
Follow Ups: