Posted by scott 56 [24.130.235.145] on Tuesday, February 10, 2015 at 12:52:49 :
In Reply to: Re: Broken or stuck screws new method? posted by Willy-N [72.171.192.59] on Tuesday, February 10, 2015 at 12:29:49 :
That is usually what i end up doing. Drilling and getting the hole off center. When you break thru the treads then you can collapse the remaining screw and pull it out. If way off, can install a helicoil later. In this case the screw is hard to get at and other times the surface where you want to start the hole is not flat.