Posted by Kevin in Ohio [192.182.160.190] on Tuesday, February 03, 2015 at 13:10:21 :
In Reply to: Re: If you do not know what you are doing posted by Willy-N [72.171.192.60] on Tuesday, February 03, 2015 at 12:16:29 :
As Bruce said, tap down with dolly behind, redrill, sand area around bare and weld. Bondo that cracks is too thick or was comprimised. I used Rage filler and was happy with it. With ant filler you NEVER, EVER wet sand it. Most fillers are like a sponge and hold water. YOU HAVE TO SEAL the filler with an epoxy primer then put your sandable primer on top of that. If you sand to the epoxy STOP.
The pic shows the top of my cab. It was pushed down over 3 inches with dents everywhere. You can see the layout die and how the file shows any high or low. Takes loads of hours to do this but the end result shows the work.
Don't let your steel stay bare very long. surface rust will start and you'll regret it later.