Re: Startin on the winch


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Greg Coffin [64.24.135.12] on Saturday, October 11, 2014 at 21:42:48 :

In Reply to: Startin on the winch posted by Nick [99.100.212.49] on Saturday, October 11, 2014 at 18:41:02 :

I'll bet most if not all of those bent parts can be straightened and salvaged. The bumpers and extensions should not be a big deal, even the rear base angle. I was able to straighten a shaft support bracket that had a 1/4" bend at the bearing. All of the winch castings are cast steel, so they should move without cracking. The bumpers, brackets and extensions are all mild steel, which is very forgiving, even without any heat.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com