I'm a lousy welder and machinist but I fabbed one up

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Sherman in Idaho [72.47.153.28] on Sunday, September 14, 2014 at 14:06:44 :

In Reply to: MU2 winch shifter fork bracket source? posted by Anthony (NM) [68.35.137.148] on Sunday, September 14, 2014 at 10:53:49 :

Nothing very precise about it. Three bits of steel scraps, some torch welding (nothing going to warp there) and some quality time with an angle grinder, and it does the job. I can't remember for sure, but I think I drilled and tapped the holes in the gear box out to 5/16 to make it a little beefier.

Follow Ups:

Re: I'm a lousy welder and machinist but I fabbed one up - Anthony (NM) 17:39:19 09/14/2014

Holes in bracket not centered? - Chriscase 18:25:25 09/14/2014
- Re: Holes in bracket not centered? - jerryinidaho 20:03:35 09/14/2014

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com