POSITIVE CAMBER

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by travis kingsbury on Friday, July 13, 2001 at 5:24AM :

I hope someone can offer some suggestions on this problem I have. My 71 W200 has a closed knuckle Dana 44 with large knuckles. I am wondering if there is any way to get the camber to 0 deg. I only have about 2000 miles on my new tires and they are starting to show some pretty good wear on the outside edge. Currenty it is probably 2 or 3 degrees positive. I am not terribly familiar with front knuckles and I don't have a manual
Travis..

Follow Ups:

Re: alignment - casebro 4:10PM 07/13/2001

Re: alignment - travis kingsbury 5:40AM 07/15/2001

How are your knuckle bearings? - Eric B. 1:52PM 07/16/2001

Re: Tight - travis kingsbury 7:13PM 07/16/2001

Tolerances? - Eric B. 7:37PM 07/17/2001

re: aligning rear axle on Danas - casebro 10:28PM 07/17/2001

Post a Followup

Name:

E-Mail:

Subject:

Message:

Optional Link

URL:

Title:

Optional Image Link

URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com