Posted by clueless [201.237.45.94] on Wednesday, May 28, 2014 at 19:01:24 :
In Reply to: lost posted by clueless [201.237.45.94] on Wednesday, May 28, 2014 at 16:16:56 :
i get ll.3 inches vs the 12.5 on the gm
would certainly fit in the wheel easy enuff 4.3 in. diameter of the hub hole and a height of 2.2
too small for what a 900 16 vs a 7.50 16
if it is good enuff for those med. duty jap trucks, which have a heavier payload than our 1 tons it would be good enuff for ours
what if one was to cut junk drums where the rotor needs to go and weld in a flange accordingly to bolt a rotor to
good use for junk drums