Re: separating drive shaft

Posted by Paul (in NY) [12.64.114.38] on Friday, October 25, 2013 at 22:38:45 :

In Reply to: separating drive shaft posted by scott 56 [24.130.234.60] on Friday, October 25, 2013 at 22:24:51 :

At the end of the short section, you will see a collar. The collar screws on and contains a grease seal. It possible the old grease is caked and helping to prevent its removal. Completely loosen the collar till it slides free out on the splines. Then anchor the broken end and try tapping with a hammer.

Paul

• How To; Pictorials for PW/M37/WC

Follow Ups:

• Re: separating drive shaft - scott 56 00:50:55 10/26/2013
  • Re: separating drive shaft - Kaegi 02:28:06 10/26/2013
    • ALONG THOSE LINES,,,, - Chriscase 09:14:58 10/26/2013
      • Re: ALONG THOSE LINES,,,, - Kaegi 13:42:35 10/26/2013
        • Re: ALONG THOSE LINES,,,, - scott 56 14:49:45 10/26/2013
          • Re: ALONG THOSE LINES,,,, - Kaegi 17:17:54 10/26/2013
      • Re: ALONG THOSE LINES,,,, - mannyc 10:43:07 10/26/2013

Post a Followup