Re: wow thanx Daryl


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by clueless [201.237.45.94] on Wednesday, October 23, 2013 at 11:25:58 :

In Reply to: Re: wow thanx Daryl posted by Daryl in Oz [210.50.251.120] on Wednesday, October 23, 2013 at 07:00:11 :

i will leave it alone--think there is bout 3/8 metal left around the taper hole the arm itself is about the same girth etc. as the dodge pitman arm--maybe a tad less--wonder if i can find a girthier pitman arm for it

i have not sucked the tie rod end all the way down yet but it is tight and my guess is there is half an inch between the two but will go back and chec and post a pic


also the spline shaft for the on the nissan box is smaller than the stock but it is well supported do to the long shaft and it s bearing support so that would be ok

the nissan box fell in my lap and at first did not think it would work and then it dawned on me to mount it where it is and then i found out about the ford box and am quite excited about it and actually i think you can mount the dodge or chevy there and do the same think but too much fanagaling with spacers etc. but the spacers would put it out far enuff so the box would clear the shackles and it looks like the spline shaft is further in on the dodge or chevy box so it may work and clear the tire as well

ideally i can use the ford box and it will be girthy and not hit the tire



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com