Re: flathead rebuild tips?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Bill Wincapaw on Thursday, May 31, 2001 at 10:06PM :

In Reply to: Re: flathead rebuild tips? posted by Vaughn on Thursday, May 31, 2001 at 9:39PM :

Charlie
I went with Stainless ex valves (VPW). I used Lubri Plate #105 motor assembly grease ( not suppose to affect bearing torque settings) on everything including packing oil pump. Get the crank & assemblies balanced. Don't know about civilian rebuild manuals but I used TM 9-1840A to do mine ( Portrayal Press). Make sure you start with 12 clips before you the wrist pins and make sure there's none on the bench when you finished putting piston/rods back in block ( I hate when that happens!!).
Regards
Bill Wincapaw


Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com