Re: reversing front spring hangers


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by clueless [201.202.29.210] on Tuesday, September 10, 2013 at 11:02:44 :

In Reply to: Re: reversing front spring hangers posted by Daryl in Oz [58.179.201.193] on Monday, September 09, 2013 at 18:08:10 :

nice to know----i think you could remove the rivets on the lower bracket and slip a pc of plate with plus or minus 1 in. flanges pointing down drill holes to match the stock bracket and bolt to it then weld the stock hangers that are in place to the new bracket thus fixing them in the exact position they need to be

then drill a bigger hole in the rear bracket to fit an eye with bushing like the front to pass from side to side and fabricate some offset hangers or use two offset factory hangers and done puppy ???

I also think this way it would still simulate the factory look to some degree depending on how good a weld job



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com