Water distribution puller and Slide hammer


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Sterling From TX [99.58.180.94] on Monday, July 29, 2013 at 10:48:47 :

I ordered a really nice slide hammer set off amazon to use with the Water distribution puller from VPW. Unfortunately the slide hammer is 7/16 course thread and the puller is 1/2 fine thread. The puller slips right over my slide hammer. i spent over an hour at the hardware store trying to modify it to fit with no luck. So my next idea is to weld a 7/16th nut onto the puller. I dont know how to weld yet but i bet if i ran it by a muffler shop they could do that easy enough. have yall encountered the same issue? Maybe a slide hammer isnt even needed. maybe just a little penetrating oil or water would permit it to come right out. Who knows! :)



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com