Re: Cani drill out the bolts? (manifold)


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Mhettinga in NM [70.57.251.208] on Tuesday, July 16, 2013 at 07:52:28 :

In Reply to: Re: Cani drill out the bolts? (manifold) posted by Sherman in Idaho [24.32.202.166] on Tuesday, July 16, 2013 at 01:24:41 :

Ya what Sherman sez. I hope on the exhaust manifold you did not cut the studs off even with the block as it leaves no room for welding on something to grasp it with. Anyhow if eithe all nuts are removed from studs or if you have cut flush with block, it should with vigorous rapping with a rubber mallet break a seal of sorts. Then apply prying techniques. Might try heating exhaust manifold only now with torch and butterfly tip. This would expand it a bit. Darned thing should come off providing all nuts are removed. Intake manifold is different beastly. Let's get the exhaust off first. Let the engine guru take the intake off.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com