Wm300 front engine mount and rear mounts Saga

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by 1361161878356MwMVgh [174.28.123.190] on Friday, June 14, 2013 at 18:21:34 :

Ordered front mount from Midwest, it's the wrong one. It measures 41/2" between the studs and is just under an inch thick. The one off my truck is 31/2 inches between studs and is 1 1/2" thick. I've tried vow and Roberts... Anyone know of another place? Anyone know where I can have my parts revulcanized?

What John sent me was for the 230 engine apparently.although his book and others indicate it works on the 251 as well, but it's not even close. No there are not extra holes in my frame, what I have is definitely stock.

Rear mounts VPW sent me squares with springs. I think( not sure) that mine had rubber mounts big ol round ones on the back, with square on the bottom of frame bolt going up through round rubber mount connecting to engine. Any ideas on this?



Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com