Posted by Keith in Washington on Tuesday, May 29, 2001 at 11:58AM :
In Reply to: Door Window installation posted by Joel C. Folman on Sunday, May 27, 2001 at 1:57PM :
I will be doing mine this week. I have the one piece windo with out a vent window. Here is what I know.
Put the window into the interior of the door and get it into the the tracks and slide it upwards until it is in the closed position. The window regulator is in place at this time. Install the front removable window channel. Crank the window regulator until the two arms are straight down you will see them throught the hole in the door. Slide the window down until the the lower track is even with the arms. Open the arms enought so that the line up with the end of the tracks. Use you hand and pull back on the spring assembly that is at the end of the arm aliging it with the track then using the regulator crank move the arm into the track. Do both arms. Roll window up slightly until the arms pass the lock holes and screw in the locks.
I also took off my PW window (with vent) in a similar manner.
|
This board is powered by the Mr. Fong Device from Cyberarmy.com |