How to prime a 230...


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Drew M. on Wednesday, May 23, 2001 at 7:58PM :

In Reply to: P.S. posted by Bill Wincapaw on Wednesday, May 23, 2001 at 6:38PM :

remove the oil pressure sensor and pour oil slowly down the oil line. It will go through the oil pump and down to the oil pan. Then insert a regular screwdriver down the dist. hole to engage the oil pump drive (bore drill w/ tip ground off in a drill works great!) and prime the block. Make sure engine is at TDC for #1 and install dist. w/ rotor pointing at #1 spark plug wire. Start, or if won't start dist may be 180 degrees off so reset dist and then start. Done. Worked fine for me and a few I shared this with. Enjoy:)
-Andy



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com