I've dynamically balanced 10,000 rpm machinery hit-or-miss...

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Chris Case [75.36.45.59] on Saturday, February 16, 2013 at 20:44:32 :

In Reply to: Re: Picked up some more stuff today! posted by Kaegi [208.54.32.215] on Saturday, February 16, 2013 at 19:07:54 :

For driveshafts I start with a hose clamp. Finish up by welding washers on.

For the 10,000 rpm woodcutting shaper I got lucky, a headed bolt replaced the set screw.

But welds don't always stick to cast iron. I would go with drilling holes most of the way through. 3, 1/2" dia. But that is permanent, better get right location.


Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com