initial tappet clearance


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Dave on Thursday, April 26, 2001 at 10:22PM :

I am just completing the final assembly on a rebuild of my 230.New .030 pistons,rings,bearings,some new guides and several new seats etc.I have set the initial tappet clearance at .014 in/.018 exh prior to the first start up. I read in a service manual that the hot clearance should be .010 int/.014 exh.Any comments or suggestions?



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com