Need correct seal for shift lever hole in 1/2 ton transfer c


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Galen [67.142.171.27] on Friday, January 11, 2013 at 19:13:08 :

I am rebuilding my Transfer Case from my 1/2 ton WC 12 and I come to an interesting problem...The seal for the shift rod hole in the case has an outside diameter of 1 3/32" and the replacement one from VPW is 1 1/4 inch. My original seal is also much thinner at (approximately 1/8inch) than the NOS one I received (approx.1/4 inch). I was told that the larger one is correct and will fit!
First off, has anyone familiar with 1/2ton WC had this problem and second, where can I get the correct seal? Thanks for your ideas.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com