Re: Clueless question?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by clueless [201.202.22.114] on Sunday, October 14, 2012 at 14:01:25 :

In Reply to: Clueless question? posted by Perry [100.1.191.128] on Saturday, October 13, 2012 at 17:24:51 :

given that it is polister and fiberglass and not epoxy I would sand it best i could and then give it a good wire brushing and then acetone it to etch it a tad and then sand it and wire brush it agasin and blow it off and shoot on the gel coat(make sure the gel coat has the wax solution in it so it will dry dry and not tacky

the resin has a wax solution in it that rises to the surface and gives you the dry resin otherwise the poliester resin(laminating) dries tacy without the wax solution so this is why it has to be roughed up before another coat goes on it

if it is an epoxy lamination it needs to be recoated with epoxy after being roughed up

poliester doen not stick well to expoxy but epoxy sticks well to poliester if roughed up properly



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com