Re: I got it out! (Thanks JD)


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Tim Way on Tuesday, March 27, 2001 at 10:08AM :

In Reply to: Axle bushing removal question posted by Tim Way on Monday, March 26, 2001 at 0:14AM :

I built a puller using JD's directions. Cost me less than $2 and took a total of 20 minutes including building the puller! It would have been faster but I had already installed the knuckle housing; kept turning while I was pulling. Oil seal and bushing came out smoothly. Man, that slide hammer beat the snot out of the seal!

When I do the other side I'll pull the bushing BEFORE re-installing the housing.

Thanks again!

Tim Way
Albuquerque, NM



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com