Help, Need a puller for NP 420 teardown


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by gtk on Wednesday, March 14, 2001 at 1:02AM :

I am looking for a puller to remove the reverse idler gear shaft in a NP420. Basically its a half moon shaped tube inside another threaded tube. The half moon slides over the slot on the idler shaft that usually holds the idler locking plate. Army manual number is 41-p-2956-50. Tried MSC, no luck. Anyone ever use a bearing splitter on the job successfully ? Don't/can't use a slide hammer as the lip for the locking plate is too thin and I have had the ends break when you use a slide hammer. No access from the other end of the idler. Any leads for the of the puller is appreciated.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com