WDX Cab and Bed Measurements


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Jim in Tucson [68.2.77.158] on Tuesday, May 01, 2012 at 03:13:24 :

Have started to bolt up all the parts on my 1947 WDX to see how everything lines up before painting and very little does. Repro running boards wouldn't fit under cab in places so cab was raised up as appropriate, fenders not lining up well and worst of all repro box (bedsides, tailgate and bed front-all new ) really looks bad - front of bed appears to be 3-4 inches lower than rear but bed front strikes somewhat high on cab ( 2-3 inches above where cab breaks -??). Oh, I almost forgot, frame is from a 1950 FFPW. Presume others have had similar problems and suggestions for a fix will be appreciated. Suppose a good start would be some measurements such as cab and running board height from ground, where on cab should bed front hit (like how far from bottom of rear window, etc, Thanks



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com