|
|
Posted by Mike O in CO [71.212.246.95] on Saturday, April 14, 2012 at 01:02:22 :
In Reply to: Re: Driveline angle question. posted by Mike Hernke [198.228.201.159] on Friday, April 13, 2012 at 16:59:36 :
Mike, here's what I have.6 cyl cummins with 2wd NV4500. Trans has slipyoke like a regular car trans. Divorce mount NP201. If I mount the transfer case directly in line with the trans, with the engine trans combo 3degrees upslope to lube the u joint, I think a single 1410 u-joint mated to the trans slipyoke at one end, and fastened with straps to the transfer case input at the other end would work. There would be no driveshaft just a slipyoke, fixed yoke and single u-joint. This would allow a longer driveline to the rear axle cause I'm running out of room.
Follow Ups: