|
|
Posted by Fleabag [96.60.222.95] on Friday, December 23, 2011 at 12:58:22 :
In Reply to: Re: 6x6 progress posted by Terry [70.48.4.204] on Friday, December 23, 2011 at 12:27:56 :
Terry, here are the parts we used, the small part is a 1/2 inch offset fill piece the next piece holds the caliper and then the hub with the rotor mounting flange welded to it. The flange that is welded on the hub cost 8.00 dollars a piece and the two other pieces I did not get the breakdown on but both together was 20.25. I can not turn the hubs like I said Bob did that, he made some jigs for the races and turned them on his lathe, the thing about the disc brake set up is the shipping of the hubs ect, it would be better to find a good machinist near you and have him do the lathe work. The set up here goes like this, first take off your backing plates the the pieces laying on the cardboard is bolted to the back side of the backing plate mounting flange on the axle housing, slide the 1/2 inch filler piece closest to the tire then the larger caliper mounting flange is mounted up against that piece, put 4 1/2 inch bolts thru the 4 holes they line up with mount the hub and rotor and then load the caliper and your good to go! Fleabag!!
Follow Ups: