Installing 237 in WC-12


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Dozerman51 [71.139.167.213] on Tuesday, November 15, 2011 at 17:53:20 :

Well I'm just about ready to Install the IND7 in the WC12. I have a few questions first though: I come up with using a 1/8" thick, by 4" long by 1&3/8" wide steel plate welded to the original mounting holes on the "Floating Power" mount to reach back to the motor mount holes on the frame. Are these the right measurements? Can I still use the Radiator support air deflector on the Radiator support? What about the fan, pulley and water pump, can I still use these after moving the Radiator forward 2"? Thanks for any advice on this matter. Joe Giraud.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com