Re: bell housing-


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by ChrisCase [76.212.215.73] on Thursday, October 13, 2011 at 18:50:41 :

In Reply to: Teardown of locked engine posted by D Sherman [72.47.9.228] on Thursday, October 13, 2011 at 18:00:02 :

I believe you can unbolt BH from block, and drive the two alignment studs into the flywheel, then lift the BH off.

The pan is bent over those two bolts. Hammer it back for socket wrench clearance.

You need a puller for the front hub- it uses bolts and big bolt in the middle.

Sounds like #1 or 2 let go.

Not much good inside- rods, oil plumbing, chain and gears?



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com