|
|
Posted by mannyc [68.165.89.2] on Tuesday, June 28, 2011 at 14:31:55 :
In Reply to: Selectro hubs installation guide posted by Don Petersen [50.46.192.224] on Tuesday, June 28, 2011 at 14:05:46 :
it is typically a case of unbolt the front drive flanges and reinstall the selectros in place. if you have the real external knob black selectros, you will find that the holes are tight and you may have to remove the studs and then reinstall studs with double nuts through the lockout and the wheel hub. use a gasket with sealant - i use anerobic permatex, but permatex #2 is fine. some guys im sure switch to cap screws, but i preferred the tight fit of the studs. i was tempted to drill and tap the flanges to accept the stock flange's puller screws, but never got to it. i think Kaegi can assist with whatever i missed here.
Follow Ups: