|
|
Posted by Bruce in BC [24.207.16.199] on Saturday, December 18, 2010 at 00:50:07 :
In Reply to: Matt OT D60 King pin axle posted by Kaegi [71.227.129.92] on Friday, December 17, 2010 at 20:45:00 :
easy to work on except for that tapered cone . i got a trick for that too . I stick a deep acorn nut into the hex socket and enough of the nut will stick out that I can use a standard socket and a 3/4 drive to remove the cone. then i heat the darn cone up from the bottom until it is red. Worked every time .....so far .
Follow Ups: