I hate to admit it but I have welded in a few new teeth

Posted by Bruce in BC [142.22.16.51] on Friday, November 19, 2010 at 20:16:56 :

In Reply to: Engine Lore... posted by dave horvath [12.130.9.139] on Friday, November 19, 2010 at 17:54:18 :

After welding i take the grinder with a cut off disc and create new teeth . Seems to work fine .

Follow Ups:

• Re: I hate to admit it but I have welded in a few new teeth - Kaegi 21:23:44 11/19/2010
  • Flipping is good too, if teeth are not factory beveled - Chriscase 21:48:18 11/19/2010
  • Or a torch and some dry ice, or just the ice. NT - Tom Hammer 21:45:13 11/19/2010

Post a Followup