Unscrew it with the cold chisel?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Chriscase [75.36.39.225] on Tuesday, October 26, 2010 at 19:12:23 :

In Reply to: OT removing MC fill plug posted by David Sherman [72.47.9.228] on Tuesday, October 26, 2010 at 18:58:48 :

Can you drive it counterclockwise with the cold chisel? Start with the chisel vertical, to get a slot, then keep hammering as you let the chisel lower, so you drive it in the un-screw direction.

Otherwise, I'd say pull the MC, disassemble, then try heat on the body to expand it until it lets go of the plug. Re-assemble after it cools. New kit, depends on your philosophical viewpoint. The only problem with many 'bad' cylinders is gunk, not worn cups. YMMV



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com