Posted by Donald F. Blair [69.88.38.158] on Wednesday, September 29, 2010 at 16:29:41 :
In Reply to: winch driveshaft needed posted by Donald F. Blair [68.244.220.126] on Wednesday, September 29, 2010 at 13:53:20 :
I may have found one. It's a piece of 1-inch steel round bar 41-1/2-inch long. At one end it's been machine with a journal for a woodruff key. The other end is splined
with a deep groove dividing the spline into
2 parts. Does that sound about right for a
winch shaft?
Thanks
Don
Follow Ups: