|
|
Posted by mike [64.136.164.35] on Monday, March 29, 2010 at 18:59:57 :
In Reply to: Re: m-37 manifolds posted by David Sherman [24.32.202.83] on Monday, March 29, 2010 at 00:24:43 :
if i try to braze, i'll leave the original intake and exhaust together. only reason i got the intake years back was concern over seperating current intake to mount to new exhaust. hoping the washers are re-usable?
i'm pretty sure i'm about to ask a stupid question, but here it goes.... bad part in casting/ start of crack in exhaust manifold is top side of elbow comming out of #1 cylinder. i'm assuming running engine to warm up entire assembly then trying to braze in place is likely not a good idia?
no responces indicating the civi 230 manifolds same as the M-37... i'm assuming i should stop eyeing the civi 230 as a doner..
thanks
mike
Follow Ups: