Re: Plymouth Doctor Restoration Parts


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by keith [98.236.84.49] on Friday, February 12, 2010 at 18:30:00 :

In Reply to: Plymouth Doctor Restoration Parts posted by Will (in IL) [98.215.26.138] on Friday, February 12, 2010 at 16:50:21 :

I have redone 1 door using these parts. The inner door panel looks teally good. out of the box. trying to install it and you will find you need to do major tweaking to get it to work. But it did work . One major problem was when I tried to put the door back on after the panels were fitted the hindges lower hindge wasent even close to aligning had to remove the hindge on the cab side and put in a vise and heat and bend it to get a close fit then put the hindge back in the truck hang the door and try to get it adjusted the way the manuel says. The outer panel is total crap dont buy that. a dodge door is not made out of flat sheet steel it has a dome shape and wont fit unless you have an english wheelor use a ton of bondo to make it look right. Plus the panels were expensive as i remember like 100 a peice. save your self a lot of time and frustration, put that 200 dollars into a good door they are around. nothing against plymouth docter but I would never do that again
Keith in West Virginia



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com