Posted by Eric B. on Monday, October 23, 2000 at 20:28:11:
A buddy of mine recently came across some lockouts that he thinks are for a W500.
He asked me to post the specs here and see if anyone could identify them.
The lockouts are 6 1/4" OD (at the flange that bolts to the hub) and 1 1/2" tall (from the bottom of the flange that bolts on the the axle to the outside of the lockout).
The part that goes into the hub has two steps, one is 4 7/8" in Diameter and about an 1/8" tall. The other step is 4 5/8" in diameter and about 3/8 of an inch tall.
The shaft that this lockout would drive is 1 3/4" on the outside of the splines, and has 19 splines.
This lockout is like a big Dualmatic, but it has four levers instead of two.
There are 8 bolts to bolt it to the hub.
This is a set of hubs and they are NOS, having been sitting on the back shelf of a drivetrain place for who knows how many years.
If anyone can identify these hubs, and or give me an approximite value, please E-mail me at ( townwagon@hotmail.com ) or reply here.
Thanks for your time!
Eric