PW U-Joints, Sources

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Will (in IL) [98.215.26.138] on Tuesday, December 29, 2009 at 15:33:55 :

Well,

I was going to have the rear drive shaft from the 46 Power Wagon checked as it does have a dent, but never noticed any vibrations/issues. However the Local Drive Shaft Shop, did not have the yokes to put the drive shaft in their equipment, and then they said, well if it had to be fixed we don't even have the ability to make or weld on a new tube. Now don't get me wrong, but if that is the case, they sure aren't much of a drive shaft shop.

So, I'll run it as is until I find a shop, or pick up another shaft. Until then, I will install the spare U-Joints I have on hand, but will need to pick up some additional spares. Where has everyone been getting the Neapco 2-1400, Spicer 5-1300X (Small Detroit) U-Joints?

Will

Follow Ups:

Re: PW U-Joints, Sources - Bob in Illinois 23:04:26 12/29/2009

Re: PW U-Joints, Sources - Will (in IL) 23:09:51 12/29/2009

Re: PW U-Joints, Sources - John S 16:29:06 12/29/2009

U-Joint 2520-656-3629 - Will (in IL) 16:04:00 12/29/2009

Re: U-Joint 2520-656-3629 - Vaughn 21:25:36 12/29/2009

Re: PW U-Joints, Sources - Bill in Pa. 15:46:09 12/29/2009

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com