Re: Which method did you use?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Nick [71.142.224.171] on Wednesday, December 16, 2009 at 10:39:45 :

In Reply to: Which method did you use? posted by Jerry in Idaho [64.139.238.43] on Wednesday, December 16, 2009 at 01:10:59 :

I used a reverse drill bit, PB blaster, a little heat, and an easy out on a couple. When the sixth one snaped it was fairly deep and left a pretty angular surface...Long story short.... the bit wandered off center and then I broke a small bit off in the hole which I was unable to retrieve making it impossible to drill larger or deeper. I couldn't get the easy out to grip well enough to pull it even though I was able to use more force than on any of the others....it must be pretty rusted in there.... Murphys Law I suppose... the other 5 were just too easy.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com