Doesn't brazing warp it too?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by David Sherman [216.18.131.223] on Sunday, November 29, 2009 at 11:41:10 :

In Reply to: Re: I know you don't want to hear this... posted by copey [206.80.248.195] on Sunday, November 29, 2009 at 08:41:27 :

I'm pretty good at brazing, so maybe I'll try it on some scrap. I assume I'd have to cut the patch over-sized, make a flange around the hole on the original panel, and figure out some way to clamp the parts while brazing. Still, even if you're careful, you have to get them to a dull orange heat for brazing, and in my experience, that's more than enough to warp steel.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com