Re: broken studs on power wagon emblem


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Daryl in Oz [210.50.14.18] on Tuesday, October 06, 2009 at 09:27:48 :

In Reply to: broken studs on power wagon emblem posted by Doc Dave [69.19.14.34] on Tuesday, October 06, 2009 at 07:12:55 :

I have used silastic (silicon rubber gasket in a tube) on the back of broken badges with a lot of success - no failures. Just put a bead of it on the back of the badge push it into place and hold it there until the goop sets - I use plastic tape to hold it - when finished trim off any excess carefully and it's done. I have attached broken badges and some with studs missing and they just seem to stay there forever. It's about the only thing I use this stuff for.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com