|
|
Posted by copey on Wednesday, May 06, 2009 at 06:58:40 :
On the last forum the was a low oil presure problem > we used to drop the pan and put oil under presuure at 30 PSI in to the sending unit > then we would look to to see if the oil leaks were at the mains, rods or cam shaft or oil pump ect > we had a air pig filled with clean oil and a flex line about 10 feet long and hook up the line and have the pig ABOVE THE ENGINE the oil would the fill the galleries and shafts ect and made for a positive check on all the above mentioned areas BUT you should have regulator on the inlet of the air pig NOT TO EXCEED 30 psi ~ Copey
Follow Ups: