|
|
Posted by Steve K. CALIF on Monday, April 20, 2009 at 13:58:23 :
In Reply to: Re: MU-2 Winch assembly question posted by Kevin Clause on Monday, April 20, 2009 at 13:49:03 :
Hello Kevin, I had looked at the Todd Somers information earlier. It is nice, but does not have the information I am seeking. I have all parts cleaned, new bushings installed, new input shaft, bearings, seals, etc. Just didn't note where worm wheel was on shaft when removed. May have to trial and error assembly of it for good line up. Thanks.