|
|
Posted by Grant in CO on Tuesday, March 03, 2009 at 12:23:31 :
In Reply to: New Clutch (1" 10 spline, thnaks Jon & Jill) posted by Will (in IL) on Monday, March 02, 2009 at 22:00:47 :
Here are part #s I have. Sorry no Prices yet
Clutch disc 1” spline (W100 / NP420) Borg & Beck 12944 11” 1 NA
Clutch disc 1.380” spline (W300) Borg & Beck 12559 11” 1 NA
Pressure plate Borg & Beck / Napa 1433 11” 1 NA
In my 64 TWPW I am putting in a NP540 from a 64 D600 with 1.380” 10 spline, but it had the NP435D with 1” 10 spline
In TWs and Sweptlines (maybe earlier with hydral. clutch?) you can use the 12" clutch that was in the D500/600:
Clutch disc 1.380” 10 spline Borg & Beck / NAPA 13363 / RCF586 12” 1 NA
Pressure plate Borg & Beck / NAPA 1575 / CA1733 12” 1 NA
beware that the actual clutch diameter is 11.87", not 12.00"!!
Alignment tool NP540 input shaft Pioneer Inc. / Drive Train Ind. DT TAT5325 1-3/8 10 spline 1 $3.20
In need to get the Throw out bearing numbers for 1.380” 10 spline??
The 540 input shaft is a bit short and only engages the pilot bearing by .75". I will need to get an extended pilot bearing
Anyone ever done this? It has the same dia. as the 1" 10 spline at .75"
G