Re: Radiator/front fender bracket mounting problem


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Vaughn on Friday, November 14, 2008 at 12:04:33 :

In Reply to: Radiator/front fender bracket mounting problem posted by Nick on Thursday, November 13, 2008 at 17:38:17 :

There are two square steel shims, one for each support stud, that go between the radiator support and engine support bracket. Specs. are: 2" x 2" x 3/16" thk. These allow the fender support braces to clear the shock mounts.

Are you sure it's a FFPW frame and not a Model B1PW26 1 ton Carryall w/Gerstenslanger Body? It has the same wheelbase length. There are also other truck frames that are within several inches of the FFPW frame wheelbase length. Does the rear crossmember have the circular hole and four screw holes /threads? If, not, it's not a FFPW frame.

If it were me, I would stop and look for a FFPW frame. Make sure you take the frame to a body shop and have it checked for alignment before you use it.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com