OT- Welding stainless exhaust with a mig question

Posted by wet coast Bruce on Saturday, June 14, 2008 at 17:38:27 :

(1) I would use my tig but it is out of commision .
(2) I got a roll of stainless for my spoolgun . I have more spatter than I am willing to deal with and the welds look like poop too . millar 200 mig machine does not show any settings . So where do I start ? Hotter or colder than the settings for steel. i will take some scrap stainless to practice on but the amount of spatter i have is silly .

Thanks

Bruce

Follow Ups:

• Re: OT- Welding stainless exhaust with a mig question - axelsteve 11:34:38 06/15/2008
• Re: OT- Welding stainless exhaust with a mig question - Vaughn 10:45:50 06/15/2008
• I have a Miller Econo twin at home - wet coast Bruce 01:12:51 06/15/2008
• Re: OT- Welding stainless exhaust with a mig question - Kevin in Ohio 23:04:34 06/14/2008
• Re: OT- Welding stainless exhaust with a mig question - dave 21:53:32 06/14/2008
  • Re: OT- Welding stainless exhaust with a mig question - axelsteve 12:20:04 06/15/2008
• I am going to try bumping up the gas pressure - wet coast Bruce 21:39:47 06/14/2008
• Re: OT- Welding stainless exhaust with a mig question - Dana (in Lancaster) 20:49:31 06/14/2008
• I am using mig mix co2 argon and the polarity is correct . - wet coast Bruce 18:57:55 06/14/2008
  • Re: I am using mig mix co2 argon and the polarity is correct . - MoparMogSteve 19:29:03 06/14/2008
• Re: OT- Welding stainless exhaust with a mig question - MoparMogSteve 18:26:13 06/14/2008
• Polarity? Gas? - chris case 18:20:41 06/14/2008
  • beat me by 6 seconds. ntxt. - MoparMogSteve 18:27:35 06/14/2008

Post a Followup