Re: gas gauge not working


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Alan on Saturday, May 10, 2008 at 17:32:12 :

In Reply to: Re: gas gauge not working posted by David Sherman on Saturday, May 10, 2008 at 12:19:39 :

That was the problem, the arm wasn't grounded. When I put an alligator clip on the sender arm and grounded it, the gauge worked. But when I push the arm all the way up, the gauge still only reads 3/4 full. Could this be from the missing resistor? I don't see a resistor anywhere between the gauge and the sending unit. What resistor do I need, and where should it go? And Steve, thanks for sending that pic, I'll solder the ground on just like that. Thanks again!



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com