|
|
Posted by Vaughn on Saturday, December 22, 2007 at 21:22:16 :
In Reply to: Would you fix this manifold? posted by D. Sherman on Saturday, December 22, 2007 at 13:07:49 :
One thing should always be done before brazing the cracks and that is dill a small hole at each end of the crack. This will prevent further cracking. Braze them up and you're good to go. The four bolts can be a challenge to get the drill centered when drilling. If the drill is off, the int. manifold mounting surface to engine block will not be flush with the exh. manifold, but will work ok if mounting surface is less than 1/4 off.
Follow Ups: