Put it into high gear?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Chris in San Diego on Sunday, December 09, 2007 at 19:31:50 :

In Reply to: tightening crank pulley bolt? posted by Carlos on Sunday, December 09, 2007 at 18:05:00 :

If that isn't tight enough, try a pry bar into a u-joint, also in high bear. Then use the hand crank to tighten it.


Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com