Posted by Paul (in NY) on Sunday, July 29, 2007 at 23:27:43 :
In Reply to: Re: Wiring Harness Suggestions posted by Brett in AK on Saturday, July 28, 2007 at 10:46:06 :
I do exactly as Brett does. Side cutters removes all old wires. Then all new wire is run. A 10 circuit ATO type fuse panel is installed. Each circuit is checked as its completed. Finally all wire is placed in split plastic loom. The finished product looks much like a factory wire job. By using this approach, you can sustom taylor for any special electrical needs rather than to add wires to a pre made harness. Keep in mind thtat any type of wireing is expensive these days. In my 'opinion' making your own harness is the only way to get a true custom harness with the quality I want.
Paul