I made a frame for my 1/2t command car


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by chriscase on Sunday, February 04, 2007 at 11:53:36 :

In Reply to: Windshield Frame Specs posted by M Fanoni on Friday, February 02, 2007 at 14:03:47 :

But I worked in a metal shop that had a 12 foot, 400 ton press break. I used 1/2" conduit. Firts i squashed it flat a bit, so it would fit on 'edge' into a box die of the right width. (3/4"?) Then, I used a piece of 5/16 steel plate as the punch, When I push the punch into the ovulated tube, it formed a nice channel for the glass. I had to pry the tube out of the box die, then curve it by hand. I didn't do it twice, so no channel for the rubber seal. It sure would freeze my hands, that wind comes under the windshield right at the 10:00 and 2:00 positions on the wheel.

It sure made a heavy duty frame, lots heavier walls than the stock tin can stuff.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com