Carb Rebuild Questions?


[ Follow Ups ] [ Post Followup ] [ Dodge Power Wagon Forum ] [ FAQ ]

Posted by Richard Rogers on April 19, 2000 at 00:12:43:

I am about to embark on rebuilding a Carter E7 Square top carb w/ integral governor. I purchased a kit from vintage power wagon. Should I attempt to rebuild & recalibrate the governor (and do parts for same even come w/ the kit) and, if so, are there any special ways? (I have manuals from vpw). Also, it seems to require special tools. Also, in removing the carb, I noticed that the gasket between carb & manifold appeared exceptionally thick. In fact, it looks as though there were several gaskets on either side of a small metal gasket-shaped piece. Is this normal, and do I need to install similar levels of gaskets to recreate original width of gasket I removed? Any suggestions would be greatly appreciated. Dick Rogers


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Dodge Power Wagon Forum ] [ FAQ ]